Micom 3R Specifiche

MICOM RM500/RM500R 500W HF-SSB Rack-Mount Continuous Duty Transceivers Owner’s Guide Table of Contents Introduction...

Table 3. RM500/RM500R Rear Panel Items (Cont.) Item Description Function 7 TX OUT Connector BNC RF output connector, for connection of unfiltered

Equipment Installation Warning For general operating and installation safety information, see the “Owner’s Guide, MICOM-3E/3T/3R HF-SSB Transceivers”

Cooling RM500/RM500R units are cooled by internal fans. Air is taken in through the front panel vent, and discharged toward the rear. Therefore, make

2. Check availability of AC power, and grounding arrangements. 3. Check antenna installation, in accordance with the antenna installation and operat

• In the transmit mode, the PPS is used as a postselector. It attenuates spurious signals and broadband noise in the driver transmit signal before it

RF OUTREMOTE CONTROLACC-J2ACC-J3ACC-J4110/220VACPARALLEL I/O SERIAL I/ODC IN+12/24 VDC GNDAC POWERTo AntennaParallelControl CableSerialControl CableA

Operation General The following instructions present operating procedures specific to the RM500 and RM500R. It is assumed that the operator is famili

Description General The MICOM RM500 and RM500R are 500W HF-SSB continuous duty radio sets. Figure 1 shows a general view of a typical 500W transceiver

Thus, the RM500 and RM500R will always attempt to transmit at the maximum safe power, even in case of mismatch. Special circuits protect the RM500 an

User-friendliness • New control head features a large LCD, full-dot matrix digital display and an enhanced keyboard for programming and set-up. • Ra

Performance Specifications Main Technical Characteristics This section presents the main technical characteristics of the RM500 and RM500R. For a list

Accessories Connectors The functions of the 25-pin accessories connectors, ACC-J1 to ACC-J4, are listed in Table 1. The connectors include PTT and CW

RM500/RM500R Main Options • USB port for external keyboard • PC control and programming software package • ALE DTM/DBM • PPS interface • Inte

Table 2. RM500 Front Panel Indicators (Cont.) Indicator Function TEMP Amplifier overheat indicator: lights when the internal temperature is too hi

RM500R Front Panel The front panel of the RM500R is shown in Figure 3. Refer to Table 2 for indicator functions. FAIL UREVOLTTEMPVSWROVER DRTXBYPASSBA